NAS
NAS How To
RAIDzilla: DIY RAID5 NAS with Attitude | RAIDzilla: DIY RAID5 NAS with Attitude |
|
|
| Terry Kennedy | |||||||||||||||||||||||||||||||||
| May 01, 2007 | |||||||||||||||||||||||||||||||||
Construction DetailsFigure 1: RAIDzilla front viewFigure 1 shows the front view of the server, which is the only part you'll see when it is installed in a rack. Most of the front is taken up by the 16 hot-swap drive bays, with a little space left on the top for the floppy, control panel, and CD-ROM. Figure 2: The carton of hard drivesFigure 2 shows a freshly-opened carton of 20 400GB Seagate Seagate Barracuda 7200.8 disk drives. It is important that all drives be identical, down to the revision of the drive and firmware, for the best RAID performance. The best way to ensure that is to purchase a case lot from the manufacturer. Figure 3: The hard drive cooling fansIn Figure 3, a view of the top of the chassis (with the cover removed), you can see the three large cooling fans that pull air in across the disk drives and then exhaust it out the back of the case. Figure 4: The motherboard, CPUs, and power supplyFigure 4 shows the back part of the case, where you can see the motherboard with two CPUs mounted (under the black plastic covers), and the triple redundant power supply on the right. Figure 5: The expansion card areaIn Figure 5, you can see a close-up picture of the expansion card area. The two 3Ware controllers are prominent in the center of the picture, with the disk cables exiting in a coil to the right. The wavy flat red and gray cables on the controllers connect to the 16 individual drive activity lights visible from the front. At the bottom of the picture are the custom orange and white Ultra-320 SCSI cables which connect bulkheads on the back of the chassis to the two internal SCSI channels. These are used to attach devices such as DLT tape drives. Figure 6: 4GB of memoryFigure 6 shows a close-up shot of the two 2GB DIMMs. For someone who has been in the computer industry as long as I have, this type of density is amazing. The first memory board I purchased new (in 1978) was 16 inches square and a half- inch thick, held a whopping 8KBytes of memory, and cost $22,000. And that was considered a major accomplishment! Added 5/3/1007 The CostRAIDzilla's cost breakdown is shown below. Keep in mind that these are 2004 prices and that the cost of some of the components has come down since then and others have been discontinued. Note that cable costs are not included, but were not a major factor.
Related Articles:New to the Charts: Sans Digital MN4L+BNew to the Charts: Promise NS2300N SmartStor Home Digital Media Server Synology announces SMB / Enterprise RAID NAS trio More Cheap and Fast RAID 5 NASes New to the Charts: D-Link DNS-343 4-Bay Network Storage Enclosure |
|||||||||||||||||||||||||||||||||
|
Open Box 409 Pro safe to buy?
Router N
need router for gaming and internet
looking for a good 200+ simultaneous connection dual-N router
New firmware 2.1.0
|
|
|
|
|
|
|
|
More |
|
You could win a Trendnet TEW-633GR Wireless N Gigabit Router and two TEW-621PC 300Mbps Wireless N-Draft PC Cards |
| Wireless Performance Charts: Belkin N+ Wireless Router |
| Router Performance Charts: Belkin N+ Wireless Router |
Nokia Plans to Launch Z-Wave Home Control Center in 2009