Router Charts

Click for Router Charts

Router Ranker

Click for Router Ranker

NAS Charts

Click for NAS Charts

NAS Ranker

Click for NAS Ranker

More Tools

Click for More Tools

NAS How To

Introduction

In Part 1 of this 'How To' we converted your old Xbox hardware to prepare it for its new life as a full-featured NAS and file server. Then in Part 2, I showed you how to install a complete LAMP-based webserver and TorrentFlux client. In this final installment, we'll add the ability to allocate bandwidth between BitTorrent and other Internet activities, and check out the file serving performance of what we've created.

NOTE!Warning:

The following section is entirely optional and the techniques in it are not for the faint-hearted! If you get it badly wrong, you can expect to have to re-attach your DVD drive and reinstall Linux from the DVD!

(That said, if you follow the instructions, you should have few problems. Besides, if it all worked first time it wouldn't be any fun and you wouldn't learn anything!)

When using your new Bittorrent client, you might find that, when downloading multiple files, your web browsing and other Internet functions slow down. This is because BitTorrent is incredibly efficient at using all the bandwidth available to it. Unfortunately, this leaves your web or SSH traffic stuck in a queue behind hundreds of BitTorrent packets, so the whole thing grinds to a halt.

This slowdown really affects only outbound traffic because most consumer Internet connections are alloted significantly lower outbound bandwidth than inbound (in the UK, 2048 kbps down and 256 kbps up is pretty common). What we need is a way to move the outbound BitTorrent queue from the ADSL modem/router to the Xbox, and to prioritize the traffic coming from our Xbox so that everything gets priority over the BitTorrent traffic. Fortunately, Linux provides us with a way of doing this!

Take a look at this document, and also this one, (the latter is specific to the Gentoo distro, but there are similarities to other Linux distros) to give you a good background of the tools and theory behind what we are going to do. All of the documents I found assumed that the Linux box was both the router and gateway. However, ours is not, so our configuration will be slightly more simple.

More NAS

Featured Sponsors


Top Ranked Routers


AC Router

AC DWS

Support Us!

If you like what we do and want to thank us, just buy something on Amazon. We'll get a small commission on anything you buy. Thanks!

Over In The Forums

Hi guys I have googled this but there is not a straight answer , so Im asking here what does the error meanupnp_event_recv: recv(): Connection reset b...
VLAN first timer here…I’m creating a VLAN and trying to get devices on that VLAN.Hardware:1 Supermicro pfSense firewall/router with 4 NICs1 Cisco SG30...
I am trying to block internet access to my security cameras so that they can only be accessed from my Synology NAS. I can use the "Block Internet Acce...
I setup OpenVPN server to client and client to server on 2x 68u with Firmware:380.65 routers.. I can't narrow it down but the VPN connection drops e...
​ QNAP's TS-228 is inexpensive, but makes performance compromises to get there.Read on SmallNetBuilder

Don't Miss These

  • 1
  • 2
  • 3