Like every other website on the planet, SmallNetBuilder uses cookies. Our cookies track login status, but we only allow admins to log in anyway, so those don't apply to you. Any other cookies you pick up during your visit come from advertisers, which we don't control.
If you continue to use the site, you agree to tolerate our use of cookies. Thank you!

Router Charts

Click for Router Charts

Router Ranker

Click for Router Ranker

NAS Charts

Click for NAS Charts

NAS Ranker

Click for NAS Ranker

More Tools

Click for More Tools

NAS Reviews

Configuration

After the install, you can unplug the monitor and keyboard and stick the computer back into the closet since all the administration is done from a very polished web interface. Point your browser at FreeNAS IP and log in using the default username and password: admin and freenas. You'll be greeted by the status page (Figure 2).

Web Configuration Home

Figure 2: Web Configuration Home

The configuration page is very nicely laid out and intuitively organized. Here's a brief run-down of the sections:

  • System: Manage static routes, update the firmware (FreeNAS), change the hostname and domain, and enable HTTPS for the web based control page.
  • Interfaces: Configure network options including IP address mode (static, DHCP), IPv6 configuration, set the MTU (allowing for jumbo frames on gigabit Ethernet, if your card supports them) and interface speed.
  • Disks: Manage RAID arrays, disk encryption, formatting and mounting.
  • Services: Set up all the file transfer and backup services.
  • Access: Set up user and group accounts and authentication.
  • Status: Monitor the health of the disks, processes, and interfaces.
  • Diagnostics: View logs, ARP tables, run traceroute and ping, backup and restore the system and reboot or shutdown the system.

Applying configuration changes was a little confusing at first—most require a three step process: make the change, "Save" the change, then "Apply" the change to have them take effect. Additionally, some changes required a "Save and Reboot" step which was a bit of a misnomer. For almost all changes, the device doesn't actually reboot (this isn't Windows), just the service is restarted.

Save and Apply

Figure 3: Save and Apply

More NAS

Wi-Fi System Tools
Check out our Wi-Fi System Charts, Ranker and Finder!

Support Us!

If you like what we do and want to thank us, just buy something on Amazon. We'll get a small commission on anything you buy. Thanks!

Over In The Forums

May 24 02:09:45 kernel: pgd = ffffffc00b209000May 24 02:09:45 kernel: [00000000] *pgd=0000000011084003, *pud=0000000011084003, *pmd=0000000001408003, ...
Hi,I'm currently on the lookout for a router that is capable of delivering speeds of 1000/1000 mbps in a small apartment (~ 350 sq ft) with only a liv...
This is my first post. Not sure if it's in the right place. My router Rt-ac68r running latest Merlin 384.11_2 has shown a strange connected clients ma...
About how fast is the AC66U-B1 or AC86U? with HW acc Disabled? WAN throughput wise? I couldn't find much other than with it most likely turned on from...
Anyone knows what this is all about?avahi_key_new() failedI get this a lot not a while and them it stops.A search on the forum reviled nothing.I keep ...

Don't Miss These

  • 1
  • 2
  • 3