Like every other website on the planet, SmallNetBuilder uses cookies. Our cookies track login status, but we only allow admins to log in anyway, so those don't apply to you. Any other cookies you pick up during your visit come from advertisers, which we don't control.
If you continue to use the site, you agree to tolerate our use of cookies. Thank you!

Router Charts

Click for Router Charts

Router Ranker

Click for Router Ranker

NAS Charts

Click for NAS Charts

NAS Ranker

Click for NAS Ranker

More Tools

Click for More Tools

NAS Reviews

Fail Recovery

Of course, one of the reasons you purchase a RAID system is for fault tolerance.  For my fail recovery test, the Media Vault was configured for RAID 1.  I had previously copied about 60GB of data and was copying an additional 4GB when I pulled the top drive (2) out.  Within about 8 seconds or so, the health indicator light turned red. Shortly thereafter, the light bar adjacent to Drive 2 went out.  

As expected, the Media Vault remained online, and my file copying continued without a hitch.  I logged into the admin console and the only notice on the home page was “alerts – view log”.  But in viewing the log, I found confusing information.  The log indicated that both drives failed (Figure 14).

Alert log showing both drives failed
Click to enlarge image

Figure 14: Alert log showing both drives failed

However, the “Disks” page reflected what was really going on (Figure 15).

Disks page showing disk 2 unavailable
Click to enlarge image

Figure 15: Disks page showing disk 2 unavailable

Since the Media Vault doesn’t “officially” support hot swap, I shut it down, re-inserted Drive 2, re-booted and found the Drive 2 “light bar” showed purple.  According to the User's Guide this means that "a hard drive has been installed, but has not been initialized". When I logged into the device, the RAID still showed as degraded on the disk page.

I clicked on the small “fix” icon and the mirror started rebuilding with an estimated 10 hour of rebuild time (which actually turned out to be 6-7 hours). Interestingly, shortly after the rebuild started, the health indicator return to normal blue status, as did the light bar next to Drive 2! This would indicate that the drive was back to fault tolerant mode. However, a check of the disk status page showed that the array was only 5% rebuilt!  This is a very misleading situation and HP should fix this as soon as possible.

More NAS

Wi-Fi System Tools
Check out our Wi-Fi System Charts, Ranker and Finder!

Support Us!

If you like what we do and want to thank us, just buy something on Amazon. We'll get a small commission on anything you buy. Thanks!

Over In The Forums

Dear FriendsI am happy owner of ASUS RT-AC86U and I have installed Asuswrt-Merlin firmware 384.9. I would like to ask you some questions:1. I use DDNS...
I use an Asus RT-AC86U and have a VPN configured with kill switch enabled. A few weeks ago, the VPN server the router was connected to had connectivit...
I recently bought a Linksys XAC1900 to be configured in bridge-mode and used as an access point hooked up to my switch. So far so good and works flawl...
HiI have currently a RT-AC87U and a RT-AC66U, where the latter is a accesspoint connected through wire to the main router. I use PIA VPN and want more...
Hi, I am new to Merlin firmware. Used to have RT-N16 on Asus firmware which was working pretty well for almost 10 years. Now, with new AC88U flashed w...

Don't Miss These

  • 1
  • 2
  • 3