Like every other website on the planet, SmallNetBuilder uses cookies. Our cookies track login status, but we only allow admins to log in anyway, so those don't apply to you. Any other cookies you pick up during your visit come from advertisers, which we don't control.
If you continue to use the site, you agree to tolerate our use of cookies. Thank you!

Wi-Fi Router Charts

Click for Wi-Fi Router Charts

Mesh System Charts

Click for Wi-Fi Mesh System Charts

The Pitch & Product

ASUS IP Sharing Gateway Router with Integrated 4-port Gigabit Switch
Summary First consumer router with 4 port gigabit Ethernet switch that supports Jumbo Frames
Update None
Pros • Gigabit Ethernet with Jumbo Frame support
• Very fast routing speed
Cons • Uncompetitive routing features and user interface
• Large throughput hit for hosted server access

ASUS IP Sharing Gateway Router with Integrated 4-port Gigabit Switch

ASUS continues to try to innovate its way into the crowded consumer networking market. Although it's not the first company to introduce a SOHO router with a built-in 10/100/1000 switch - that would be D-Link's DGL-4300 [reviewed here] - it is the first to have that four-port switch support Jumbo Frames. Unfortunately, this spiffy little gigabit Ethernet switch comes as part of a router that's nowhere near as impressive.

The RX3141 is about the size of a typical business tome with all indicators on the front and connectors on the rear. It's not made for standing vertically on a desk, but has mounting screw slots on the bottom along with two reasonably strong magnets in case you'd like to throw it up onto the side of a file cabinet.

Figure 1 shows the router is powered by a Winbond W90N740 32-bit ARM7TDMI-based MCU. It has built-in support for two 10/100 Ethernet MACs and a USB 1.1 host controller hub with one port tranceiver.

RX3141 board

Figure 1: RX3141 board
(click image to enlarge)

The gigabit switch comes courtesy of a Broadcom BCM5385, which is under the heatsink shown at the upper left-hand corner of Figure 1. This is the same switch used in the D-Link DGL-4300, but ASUS has chosen to enable the built-in Jumbo Frames capability, whereas D-Link did not.

Tip! TIP: Jumbo Frames are simply Ethernet frames (packets) larger than 1500 Bytes and you'll see why supporting them is desirable when I review my test results. If you'd like additional background on Jumbo Frames try this article.

The rest of the design is pretty straightforward, with a Realtek RTL8201CP 10/100 Ethernet "PHYceiver" for the 10/100 WAN port, and 2 MBytes of flash and 16 MBytes of SDRAM.

Support Us!

If you like what we do and want to thank us, just buy something on Amazon. We'll get a small commission on anything you buy. Thanks!

Don't Miss These

  • 1
  • 2