Like every other website on the planet, SmallNetBuilder uses cookies. Our cookies track login status, but we only allow admins to log in anyway, so those don't apply to you. Any other cookies you pick up during your visit come from advertisers, which we don't control.
If you continue to use the site, you agree to tolerate our use of cookies. Thank you!

Router Charts

Click for Router Charts

Router Ranker

Click for Router Ranker

NAS Charts

Click for NAS Charts

NAS Ranker

Click for NAS Ranker

More Tools

Click for More Tools

Wireless Reviews

Wireless Performance

Since NETGEAR is holding off on shipping their tri-mode AP and router, I had to make do with a combination of their WAB102 802.11a/b and WG602 draft-11g [reviewed here] Access Points to put the WAG511 through its paces. Since the table below shows a summary of the draft-11g test results, I'll start there.

The draft-11g performance seems to provide the best combination of speed and range in my residential test environment. The table shows surprisingly consistent performance in three of my test locations, with performance degrading slightly at my longest range test point. Figure 7 shows the results from my Chariot tests.

NETGEAR WAG511 - 11g throughput plot

Figure 7 : Draft-11g throughput
(click on the image for a full-sized view)

Although the plots are a little tough to make out, I think you can get the general picture. I also ran a throughput check with WEP enabled, which is shown in Figure 8.

NETGEAR WAG511 - w, w/o WEP

Figure 8: With and without WEP
(click on the image for a full-sized view)

The difference between average throughputs is only about 4%, which I say is close enough and probably within the accuracy of my measurements.

The WAG511's performance is definitely superior to that of the NETGEAR's Intersil-based WG511 single-band draft-11g card, shown in Figure 9.

NETGEAR WG602- Throughput test

Figure 9: Four Condition Throughput - NETGEAR WG511 and WG602
(click on the image for a full-sized view)

This is the plot from the WG602 review, where I used the same WG602, with the same 1.04.00 firmware. I think the results speak for themselves.

More Wireless

Wi-Fi System Tools
Check out our Wi-Fi System Charts, Ranker and Finder!

Support Us!

If you like what we do and want to thank us, just buy something on Amazon. We'll get a small commission on anything you buy. Thanks!

Over In The Forums

Hi,in the latest couple of weeks, some time after I updated to latest Merlin after over an year (with factory reset), I noticed that when connected wi...
This is FlexQoS, a fork of the original, groundbreaking FreshJR_QOS script written by @FreshJR.FlexQoS provides a fully customizable Adaptive QoS expe...
@JGrana, I agree.Is there a 10-step program/tutorial for GitHub navigation/comprehension?
Hi allJust got a AX88U and so far setup has been fine. But I ran into a issue. My laptop runs a Intel dual band 1x1 3165 adaptor. I can connect to the...
v4.0.0Updated 2020-11-22spdMerlin is an internet speedtest and monitoring tool for AsusWRT Merlin with charts for daily, weekly and monthly summaries....

Don't Miss These

  • 1
  • 2
  • 3