Like every other website on the planet, SmallNetBuilder uses cookies. Our cookies track login status, but we only allow admins to log in anyway, so those don't apply to you. Any other cookies you pick up during your visit come from advertisers, which we don't control.
If you continue to use the site, you agree to tolerate our use of cookies. Thank you!

Router Charts

Click for Router Charts

Router Ranker

Click for Router Ranker

NAS Charts

Click for NAS Charts

NAS Ranker

Click for NAS Ranker

More Tools

Click for More Tools

Wireless Reviews

I covered the design details of the G2 in this Inside Story article, but, to recap, the design is based around the Broadcom BCM5354 802.11b/g Router System-on-Chip with BroadRange Technology, 8 MB of RAM and 2 MB of flash.

The circuit design is essentially the same as the most recent WRT54G boards (the WRT54GV8 and WRT54GV82). The key difference in the G2 is that it uses dual internal, fixed position, non-upgradeable antennas vs. the external, movable, upgradeable antennas found on the WRT54G.

The feature set of the G2 is essentially unchanged from that of the G.

Routing performance measured around 72 Mbps in the WAN to LAN and LAN to WAN tests. But when both directions were run simultaneously, average throughput for the 1 minute IxChariot run dropped to 45 Mbps, due to what appeared to be a battle for throughput between up and download that resulted in WAN to LAN traffic grinding to a virtual halt for most of the run.

This inability to handle full-speed traffic in both directions simultaneously caused a dismal performance in the Maximum Simultaneous Connections test of only 8 connections (4 up, 4 down).

Wireless performance was tested with the latest-generation WPC54G V3.1 card, which uses a Broadcom BCM4318 AirForce One Single-Chip 802.11g Transceiver. The router and card stayed connected during my open-air "walkaround" test in the difficult test Locations 4 and 5 with 1-2 Mbps throughput.

But the throughput vs. path loss tests run in the Azimuth tester showed slightly shorter range and a faster falloff in throughput than the WRT54GV5 and WPC54G V3 pair.

Check out the slideshow for internal details and a GUI tour and the Router and Wireless Charts to run your own comparisons.

Updated 6/19/2008 - Read the full review.

More Wireless

Wi-Fi System Tools
Check out our Wi-Fi System Charts, Ranker and Finder!

Support Us!

If you like what we do and want to thank us, just buy something on Amazon. We'll get a small commission on anything you buy. Thanks!

Over In The Forums

Hello everyone,I'm having an issue with USB tethering an android phone as a backup internet device to the AX11000 router. I have all the failover and ...
It just came in my attention that NetGear released it new Wi-Fi 6 Extender: https://www.snbforums.com/threads/netgear-intros-tri-band-wi-fi-6-router-a...
Hi..Is there an iptable or script I can use to block a specific device (IP) from accessing a specific website?
So I am trying to configure my router to have a wired guest network on port 4. Ideally I would like to limit its bandwidth to 50% on the internet.Now ...
I have been watching my laptop wireless 5Ghz speed change over time. I am just letting my laptop sit and the speed is changing from 5xx to7xx over a m...

Don't Miss These

  • 1
  • 2
  • 3