Like every other website on the planet, SmallNetBuilder uses cookies. Our cookies track login status, but we only allow admins to log in anyway, so those don't apply to you. Any other cookies you pick up during your visit come from advertisers, which we don't control.
If you continue to use the site, you agree to tolerate our use of cookies. Thank you!

Wi-Fi Router Charts

Click for Wi-Fi Router Charts

Mesh System Charts

Click for Wi-Fi Mesh System Charts

Choosing Hardware

Astlinux is available in several versions, each of which targets a different hardware platform.

I am familiar with the Soekris single board computer hardware, having previously used the excellent open source m0n0wall router on a Soekris Net4501 system. Thus, for this review, I chose the version compiled for the Soekris Net4801 single board computer. This SBC is based upon a National Semiconductor Geode SC1100 processor, which is essentially a 266 MHz 486 class processor. In addition, the Net4801 provides the following hardware features:

  • 256 MB SDRAM, soldered on board
  • 4 Mbit BIOS/BOOT Flash
  • CompactFlash Type I/II socket, 8 MByte Flash to 4 GByte Microdrive
  • UltraDMA/33 interface with 44 pin connector for 2.5" Hard Drive
  • Three 10/100 Mbit Ethernet ports (RJ-45)
  • Two Serial ports (DB9 and 10-pin header)
  • USB 1.1 interface
  • Power LED, Activity LED, Error LED
  • Mini-PCI type III socket
  • PCI Slot, right angle, 3.3V signaling only

When ordered with a suitable case and power supply, the completed system costs around $260.

Soekris Net4801, CF card, USB key & power supply

Figure 1: Soekris Net4801, CF card, USB key & power supply

The Net4801 card is very small, and even the switching power supply is tiny. While the Net4801 supports an IDE hard drive, for this project the system will boot from a CF card, so it will have literally no moving parts. Since the system is destined for my home office, the fact that it is dead silent is a significant benefit.

In my earlier Asterisk installation, I had been using a Digium TDM-400p card to provide two analog line interfaces (FXO ports) to bring my lines from the telephone company into the Asterisk server. However, the basic case offered by Soekris Engineering does not provide sufficient space to fit a PCI card such as the TDM-400p.

Soekris Net4801 and Digium TDM-400 card with 2 FXO ports

Figure 2: Soekris Net4801 and Digium TDM-400 card with 2 FXO ports.
Note that the card will not fit into the case.

Soekris does provide cases that will hold the Net4801 and multi-port LAN cards. In fact, they even offer a bundle combining the Net4801 with a Sangoma T-1 card, a suitable case and power supply. But for my home office, a T-1 interface supporting 24 lines is overkill.

For this new installation I have decided that instead of using the TDM-400p card, I will simply call forward the analog lines to a phone number that is provided over IP from an online service provider. This way, if ever I have trouble with Astlinux, I can defeat the call forwarding and answer the main line using a plain vanilla analog phone that I keep on hand for just such an emergency. Given this strategy, the TDM-400p card is not required, which means the smallest, most basic case is adequate for this installation.

Support Us!

If you like what we do and want to thank us, just buy something on Amazon. We'll get a small commission on anything you buy. Thanks!

Don't Miss These

  • 1
  • 2