Like every other website on the planet, SmallNetBuilder uses cookies. Our cookies track login status, but we only allow admins to log in anyway, so those don't apply to you. Any other cookies you pick up during your visit come from advertisers, which we don't control.
If you continue to use the site, you agree to tolerate our use of cookies. Thank you!

Router Charts

Click for Router Charts

Router Ranker

Click for Router Ranker

NAS Charts

Click for NAS Charts

NAS Ranker

Click for NAS Ranker

More Tools

Click for More Tools

LAN & WAN Reviews

Admin and Setup" />

Admin and Setup

Admin is via a browser-based interface that uses multiple frames. Figure 1 shows a sample window.

Xincom Dual-WAN: Load Balance Screen

Figure 1: Load Balance Screen
(click on the image for a full-sized view)

The left frame is fixed size, but the right-hand frame resizes to track your browser window size. The interface has quick navigation from screen to screen and short pauses to save settings. You can have multiple admins logged in simultaneously without the router complaining and there's no login timeout. I didn't like, though, that the left-hand menu and overly-large top banner frames would display without being logged into the router.

WAN-side remote admin and firmware update can be enabled and restricted to range of IP addresses, but I found response to be so slow as to be unusable when I tried out the feature.

More LAN & WAN

Wi-Fi System Tools
Check out our Wi-Fi System Charts, Ranker and Finder!

Support Us!

If you like what we do and want to thank us, just buy something on Amazon. We'll get a small commission on anything you buy. Thanks!

Over In The Forums

Hey guysAnybody else using this yet? Seems stable but on mine it no longer measure upload bandwidth properly. Might not be Merlin, might be the stock ...
Hi - I've been having odd issues with my AC86U mesh setup, and I'm not even sure where to start troubleshooting or searching for how to fix the proble...
My setup is an NVIDIA Shield TV Pro (2019) running a PLEX server with the media stored on a hard drive plugged into my Asus RT-AC68U (Merlin Firmware ...
I've been struggling with my AC66U (old rev.) speed issues, finally I narrowed it down to IPv6. When I enable 6in4, my speed over ipv4 gets capped at ...
Is there a way to show the list of connected devices from the command line on the Orbi running Voxel firmware? While the device list is available on t...

Don't Miss These

  • 1
  • 2
  • 3