Like every other website on the planet, SmallNetBuilder uses cookies. Our cookies track login status, but we only allow admins to log in anyway, so those don't apply to you. Any other cookies you pick up during your visit come from advertisers, which we don't control.
If you continue to use the site, you agree to tolerate our use of cookies. Thank you!

Router Charts

Click for Router Charts

Router Ranker

Click for Router Ranker

NAS Charts

Click for NAS Charts

NAS Ranker

Click for NAS Ranker

More Tools

Click for More Tools

NAS Reviews

Introduction

Synology DS207 Disk Station

At a Glance
Product Synology Disk Station (DS207)
Summary Dual-drive BYOD SATA RAID 1 NAS with Active Directory and AFP support.
Pros • LAMP webserver (HTTP, PHP and MySQL support)
• UPnP AV Media, iTunes, proprietary photo and USB print servers
• Built in BitTorrent, HTTP, FTP download service
• Gigabit Ethernet with 4K and 8K Jumbo frames supported
Cons • iTunes server doesn't support Apple DRM files
• Can't modify created volumes
• Only RAID1 volume expansion supported

Update 11/13/2007: Also available as the faster DS207+, with Marvell "Orion" processor and 128MB of RAM.

Synology and Thecus are two aggressive NAS producers that have their sights set on stealing some of Buffalo Technology's dominant share of the consumer NAS market with full-featured BYOD NASes. Last year Jim Buzbee looked at the single-drive DS-106e and Bill Meade the quad-drive RAID 5 CS-406. You can think of the DS207 as something in between the two, with styling more akin to the CS-406, but hardware design closer to the 106e.

The attractive while plastic enclosure provides easy access to the innards for disk installation by removing two screws and sliding the larger cover forward. Front and rear panel details are shown in Figure 1. The "USB Copy button" arrow in the Front View below actually points to the front panel USB 2.0 port (the actual button is right below the port). Don't get too excited about the removable plastic plug above the Power button—there's no connector under it.

Two more USB 2.0 ports are found on the back with a 10/100/1000 Ethernet port that supports jumbo frames in increments of 1000 up to 9000, Reset button and power socket. The power cord clip below the socket is a thoughtful touch.

DS-207 Front and Rear Panels

Figure 1: DS-207 Front and Rear Panels

As noted above, getting inside to install your drives is easy and Synology provides all the cables and screws that you'll need. Figure 2 shows the drives sit piggy-back held by two metal brackets that are removable from a metal base plate for mounting ease.

DS207 Inside view
Click to enlarge image

Figure 2: DS207 Inside view

The board detail shot in Figure 3 shows a design similar to that of the DS-106e, based around a 266 MHz Motorola Freescale MPC8241. Gigabit Ethernet support is provided by a Marvell Yukon 88E8001, the SATA controller is a Silicon Image SATALink 3512 and the USB controller is provided by an NEC D720101 USB 2.0 Host Controller. RAM and Flash have been doubled, however, to 64 and 4 MB respectively from the 106e.

Detail view of board
Click to enlarge image

Figure 3: Detail view of board

Due to popular request, we've started to measure NAS power consumption. The 207 averaged around 32W while active and 16W when in "hibernation".

More NAS

Wi-Fi System Tools
Check out the new Wi-Fi System Charts, Ranker and Finder!

Featured Sponsors



Support Us!

If you like what we do and want to thank us, just buy something on Amazon. We'll get a small commission on anything you buy. Thanks!

Over In The Forums

Is it possible to control LAN access via iptables? I have a bunch of IOT devices that I want to access the internet and (and this is the kicker) accep...
I recently enabled the statistics for traffic analyzer, and in the list of clients I was seeing this mac address I couldn't find on my network , I fou...
just a quick question, I have an rt-ac56u with 378.55 firmware on it, is it possible to update from 378.55 to 384.5 or is this too much of a jump??
HelloSorry if this is a repost of the same topic somewhere else.Im having issues when looking for devices at the traffic analizer page. I can see all ...
Hi all I have to put a new iptable rule. For that I have created a script and named it "firewall-start" and located it under /jffs/scripts/If I run th...

Don't Miss These

  • 1
  • 2
  • 3