Like every other website on the planet, SmallNetBuilder uses cookies. Our cookies track login status, but we only allow admins to log in anyway, so those don't apply to you. Any other cookies you pick up during your visit come from advertisers, which we don't control.
If you continue to use the site, you agree to tolerate our use of cookies. Thank you!

Router Charts

Click for Router Charts

Router Ranker

Click for Router Ranker

NAS Charts

Click for NAS Charts

NAS Ranker

Click for NAS Ranker

More Tools

Click for More Tools

NAS Reviews

Introduction

Seagate BlackArmor NAS 220

At a Glance
Product Seagate BlackArmor NAS 220 (ST320005LSA10G-RK)
Summary Two drive RAID 1 NAS with encrypted volume support, lots of backup options, media servers and secure web-based remote access.
Pros • Good value ($ / capacity)
• 5 Windows client licenses for full-featured backup software
• Secure web-based remote access
Cons • No Logging
• No MacOS backup client or Time Machine support
• No RAID migration / expansion
• Slow USB backups
• No eSATA support

Seagate must be pleased with the acceptance of its four-drive BlackArmor NAS 440, because they're back with a two-drive version. The NAS 220 supports most of the features of its higher-capacity sibling, which we've previously reviewed. So I'll just focus on what's different, review its new hardware platform and run through the performance test results.

The 220 is housed in a metal case with a plastic front panel. It's a no-frills design meant to convey a no-nonsense approach designed to appeal to its target small-biz buyer. It's a bit taller and wider than the Synology dual-drive NASes, but not quite as big as Cisco's Linksys Media Hub.

Figure 1 shows the front and rear panels. The front has status and drive activity indicators, the Power button but no USB ports, while the rear has two USB 2.0 ports and a Gigabit Ethernet port that supports jumbo frames up to 9K. Unfortunately, it has no eSATA port to help support faster backups to attached drives.

Front and rear panels

Figure 1: Front and rear panels

The single fan ran quietly and drive noise was low enough to make the unit barely audible in a quiet room. I didn't hear the fan speed ramp up during the load of our performance testing. Power draw measured 22 W active and 7 W with drives spun down via the HDD Standby feature. You can't set the spindown time and there is no programmable shutdown / startup feature.

Internal Details

The 220's metal case has a plastic front panel that doesn't easily remove to provide access to the two 3.5" SATA drives. For that, you need to remove three screws and slide off the metal cover to reveal the two toaster-style top-inserted drives (Figure 2). Our 2 TB review model came with two ST31000528AS Barracuda 7200.12 1 TB drives installed, which are EXT3 formatted.

Inside view
Click to enlarge image

Figure 2: Inside view

Figure 3 is a shot of the 220's board, which is mounted below the drive cage. The board is not the same as the BA NAS 440 and uses a slower version of the Marvell "Kirkwood" SoC line, an 800 MHz 88F6192 vs. the BA 440's 1.2 GHz 88F6281.

NAS 220 board
Click to enlarge image

Figure 3: NAS 220 board

Other key components are a Marvell 88E1116R Gigabit Ethernet, 128 MB of soldered-on RAM, 32 MB of flash and a Genesys GL850A 4 port USB 2.0 Hub. Note the unloaded position for a second RAM chip.

More NAS

Wi-Fi System Tools
Check out our Wi-Fi System Charts, Ranker and Finder!

Support Us!

If you like what we do and want to thank us, just buy something on Amazon. We'll get a small commission on anything you buy. Thanks!

Over In The Forums

Hi, I have an AImesh system with 2 RT-AC68U connected with cable, the first in my house the second in garage/garden. I have about 50 wifi devices conn...
Hi guys,I tried to check more info about the region selection (also in this forum), looking at the real differences in terms of power limitation and c...
I'm wondering whether this is possible to do on the AC86U router. I'm thinking about setting up a RPi that will run a proxy server with a Wireguard VP...
I have several 2.4 Ghz smart devices connected to my RT-AC86U router currently running Merlin 384.15 firmware. As repeatedly advised, I have these dev...
I need a fast vpn router for online gaming and streaming from target.

Don't Miss These

  • 1
  • 2
  • 3