Like every other website on the planet, SmallNetBuilder uses cookies. Our cookies track login status, but we only allow admins to log in anyway, so those don't apply to you. Any other cookies you pick up during your visit come from advertisers, which we don't control.
If you continue to use the site, you agree to tolerate our use of cookies. Thank you!

Router Charts

Click for Router Charts

Router Ranker

Click for Router Ranker

NAS Charts

Click for NAS Charts

NAS Ranker

Click for NAS Ranker

More Tools

Click for More Tools

NAS Reviews

Performance - Summaries

4.0.1 firmware was loaded on a TS-421 for our standard NAS test process. Given that all three models use the same processor, RAM and Ethernet components, all testing was done on the TS-421 sample. The TS-421 tests used four drives configured in single RAID 0, 5 and 10 volumes. The TS-221 tests used two drives in single RAID 0 and 1 volumes. The TS-121 tests used one drive.

As noted in the TS-421 review, times to completely build and resync 4 x 3 TB RAID 5 and 10 volumes were quite long at 17h 20m and 22h 30m, respectively. Unlike Thecus and Synology, QNAP does not offer the option to skip a bad block test, which can speed volume resync times significantly.

Since we have the NAS Ranker, I'll only make a few observations about each benchmark summary. The TS-421's Benchmark Summary below shows Windows File Copy write performance about the same (~44 MB/s) for RAID 0 and 10, but dropping to 36 MB/s for the more CPU-intensive RAID 5. File Copy read takes a different tack, with a slight upward trend from RAID 0 through RAID 10 (66, 72 and 73 MB/s).

NASPT File copy results are lower than their Windows File Copy counterparts across the board for both write and read.

QNAP TS-421 Benchmark Summary

QNAP TS-421 Benchmark Summary

Please note that I copied the Network Backup (rsync) results from the TS-421 to the TS-221 and TS-121 for NAS Ranker consistency. There rsync bug found in the original TS-421 review that required hand-editing of the rsync.conf file had not been fixed as of the retest.

With two drives representing the TS-221's performance, RAID 0 performance is slightly higher than with four drives. Windows file copy for RAID 1 measured 50 MB/s for write and 78 MB/s for read. NASPT file copy was also a bit higher (38 vs. 33 MB/s) for write and almost 15 MB/s higher for read.

QNAP TS-221 Benchmark Summary

QNAP TS-221 Benchmark Summary

With only a single drive, both write and read performance dipped to 46 and 71 MB/s for Windows file copy and 33 MB/s and 68 MB/s for NASPT file copy.

QNAP TS-121 Benchmark Summary

QNAP TS-121 Benchmark Summary

More NAS

Wi-Fi System Tools
Check out our Wi-Fi System Charts, Ranker and Finder!

Support Us!

If you like what we do and want to thank us, just buy something on Amazon. We'll get a small commission on anything you buy. Thanks!

Over In The Forums

Dear FriendsI am happy owner of ASUS RT-AC86U and I have installed Asuswrt-Merlin firmware 384.9. I would like to ask you some questions:1. I use DDNS...
I use an Asus RT-AC86U and have a VPN configured with kill switch enabled. A few weeks ago, the VPN server the router was connected to had connectivit...
I recently bought a Linksys XAC1900 to be configured in bridge-mode and used as an access point hooked up to my switch. So far so good and works flawl...
HiI have currently a RT-AC87U and a RT-AC66U, where the latter is a accesspoint connected through wire to the main router. I use PIA VPN and want more...
Hi, I am new to Merlin firmware. Used to have RT-N16 on Asus firmware which was working pretty well for almost 10 years. Now, with new AC88U flashed w...

Don't Miss These

  • 1
  • 2
  • 3