Like every other website on the planet, SmallNetBuilder uses cookies. Our cookies track login status, but we only allow admins to log in anyway, so those don't apply to you. Any other cookies you pick up during your visit come from advertisers, which we don't control.
If you continue to use the site, you agree to tolerate our use of cookies. Thank you!

Router Charts

Click for Router Charts

Router Ranker

Click for Router Ranker

NAS Charts

Click for NAS Charts

NAS Ranker

Click for NAS Ranker

More Tools

Click for More Tools

Inside Story

The base station (Figure 3) has a TI TNETV1060 VoIP gateway chipset at its core, which integrates TI's programmable TMS320C55x DSP, a MIPS32 4KEc processor, and Telogy Software for VoIP.

Base station internal view

Figure 3: Base station internal view
(click image to enlarge)

Figure 4 shows the dual-band 2.4 / 5.8 GHz radio board that plugs into the processor board, the construction of which I couldn't tell much about from the FCC pictures. And yes, I said dual-band, which you might think means that this phone system and your 802.11b/g wireless LAN won't play well together. But as I found out, this wasn't the case.

Base station radio board

Figure 4: Base station radio board
(click image to enlarge)

Figure 5 shows the handset's innards, which near as I can tell use a Philips ARM-based processor at the core.

Handset internal view

Figure 5: Handset internal view
(click image to enlarge)
Wi-Fi System Tools
Check out our Wi-Fi System Charts, Ranker and Finder!

Support Us!

If you like what we do and want to thank us, just buy something on Amazon. We'll get a small commission on anything you buy. Thanks!

Over In The Forums

One of the reasons I just bought an AC68U was because I wanted the Traffic Analyzer.Apparently enabling this requires "that your information will be c...
Im sure this question has been asked before but I am trying to connect my AC3200 to a Meraki MX64. MX64 supports L2TP with PSK. Asus Merlin doesnt hav...
Hey allSo i have two netgear switch models.I have two nighthawk s8000 and two netgear GS 108's. Both 8 ports. My cable is 1 gigabit and and my system ...
So, I currently have 2 routers. One is a Linksys and the other is an ASUS, I don't think models really make a difference in the scenario. Basically, I...
When I click on "guest Network" I get this screen instead of the normal setup screen. Any ideas? total noob here...thanks

Don't Miss These

  • 1
  • 2
  • 3