Like every other website on the planet, SmallNetBuilder uses cookies. Our cookies track login status, but we only allow admins to log in anyway, so those don't apply to you. Any other cookies you pick up during your visit come from advertisers, which we don't control.
If you continue to use the site, you agree to tolerate our use of cookies. Thank you!

Router Charts

Click for Router Charts

Router Ranker

Click for Router Ranker

NAS Charts

Click for NAS Charts

NAS Ranker

Click for NAS Ranker

More Tools

Click for More Tools

Wireless Reviews

Wireless Performance

Since the WLA2 is Broadcom-based and 11g compliant, I expected performance similar to the Belkin F5D7130. However my testing with a BuffaloTech WLI-CB-G54 CardBus card showed that Buffalo's "throughput hopping" behavior is still present as shown in Figure 2.

BuffaloTech WLA2G54- Four location throughput

Figure 2: Four location throughput
(click on the image for a full-sized view)

Further testing with a Belkin F5D7010 CardBus card - also 11g spec-compliant and WPA-enabled - showed that the "hopping" seems to be related to the client card and not the WLA2. A close-range Condition 1 test with the Belkin card showed a steady throughput plot - although not without a few significant throughput "dropouts" - with average throughput of 22.6Mbps compared to the 20.8Mbps average obtained using the Buffalo Tech card.

This doesn't necessarily mean that the Belkin card was better. I ended up comparing Condition 1 throughput in three security modes - WEP 128, WPA-PSK / TKIP, and WPA-PSK / AES - for both cards and found odd behavior in each case. I was especially concerned at the drastic difference between two runs taken a few hours apart for both cards.

More Wireless

Wi-Fi System Tools
Check out our Wi-Fi System Charts, Ranker and Finder!

Support Us!

If you like what we do and want to thank us, just buy something on Amazon. We'll get a small commission on anything you buy. Thanks!

Over In The Forums

I have an Asus AC-68U acting as the Primary Router running 384.14. When I enable IPv6 and set it to Native Mode, i can see IPv6 address on my interfac...
Hello everyone,I have posted my problems with a QNAP TS-212P and duplicate files and directories/files being renamed :https://www.snbforums.com/thread...
Just curious as to why the vertical axis on the 24-hour traffic analyser is not set to display the data better...View attachment 20951
HelloI use an rt-ac68u and a dsl-ac68u with stock firmware as aimesh nodes. Is it possible to use their ethernet ports too? I tried to connect a PC li...
Hi everyone,I have been trying to set things up (as per the attached LL design), but I was wondering if anybody can help maybe and stop me if I'm head...

Don't Miss These

  • 1
  • 2
  • 3