Router Charts

Click for Router Charts

Router Ranker

Click for Router Ranker

NAS Charts

Click for NAS Charts

NAS Ranker

Click for NAS Ranker

More Tools

Click for More Tools

Wireless Reviews

The N+ is one step up from Belkin's entry-level draft 802.11n router (the N Wireless) and is differentiated from that model by its gigabit WAN and LAN ports and a USB port that will make a USB flash or hard drive available as a networked share.

The two-antenna design (2T2R) uses a Ralink RT2880 SoC that supports 125 Mbps of routing throughput and at least 200 simultaneous connections. As with other Belkin routers, routing features are basic, with no QoS or content filtering.

Wireless features include a Guest Access mode providing Internet access isolated from internal LAN and WLAN clients via a separate SSID. Guest access can be secured via a password-protected captive web portal or a separate WPA/WPA2 passphrase.

The N+ and its companion N+ Wireless USB Adapter support Wi-Fi Protected Setup (WPS), WEP and only the Personal (PSK) modes for WPA and WPA2.

Unlike the Belkin N, which had no significant throughput degradation in WEP, WPA/TKIP or WPA2 wireless security modes, the N+ and N+ USB adapter reduced speed when connecting in WEP and WPA/TKIP when running uplink and only WEP running downlink.

Wireless best-case throughput in the default 20 MHz bandwidth mode averaged 61 Mbps running downlink and 70 Mbps uplink over a 1 minute test. Switching to 40 MHz mode improved throughput to 84 and 85 Mbps for down and uplink, respectively.

Read the full review.

More Wireless

Zyxel logo

Wi-Fi Mesh System Secrets - Here's how to get the most out of your whole home mesh WiFi system.

Wi-Fi System Tools
Check out the new Wi-Fi System Charts, Ranker and Finder!

Featured Sponsors



Support Us!

If you like what we do and want to thank us, just buy something on Amazon. We'll get a small commission on anything you buy. Thanks!

Over In The Forums

I recently decided to go full-retard and on a recent trip to the US I bought a GT-5300, an RT-5300 and an RT-AC88U. My idea is to set up an AiMesh net...
Hi Community. I currently got a AC68U running Merlin 384.4_2. I recently purchased a AC86U. I would like to use my new 86U as my router in my upstairs...
I have the RT-AC68U with Merlin's 384.4. All I want to do is make Usenet binary downloads the lowest priority. They all go through port 563 using SSL....
Hi all I just got a qnap ts-453a raid device and started a raid 10 array using four 8tb has drives. Is it normal for a blank raid array to take ~40 ho...
I have a network with 35-40 clients. network is running two 86u's in aimesh with smart connect. stability and performance have been good with 1 except...

Don't Miss These

  • 1
  • 2
  • 3