Router Ranker and Charts Improvements

Photo of author

Tim Higgins

Router Ranker Changes

We have improved the Router Ranker again. Read about the changes here.

Router Ranker use has grown steadily since its introduction in April and it is now the second most-visited page on SmallNetBuilder. To help make it provide a more balanced view of router performance, we’ve made a slight change to the router ranking algorithm.

Router rank was previously determined by equally combining the ranks for wired routing performance, wireless throughput performance and wireless range performance. Wireless throughput rank was based on a single test for each benchmark: "Location A" for products tested with the older open-air method; and 0 dB attenutation for products tested with the current method.

Since there is more to a router’s wireless performance than just the highest throughput it can produce, we have added average wireless throughput to the total rank algorithm. This is the same number you see when you view the 2.4 GHz Downlink, 2.4 GHz Uplink, 5 GHz Downlink or 5 GHz Uplink Router Chart default views. We combine ranks for all four values, weighted equally and then combine that average, again weighted equally, with the three other existing ranks.

The screenshot below shows the new view produced by clicking on the Performance link in the Ranker default view.

Performance summary - previous

Ranking performance summary – previous

Here’s the old view below for comparison. As with the other ranks, you can see the actual performance benchmark values that are used for the new Average Wireless Throughput ranking. Note that routers are still ranked by wireless class.

Performance summary - previous

Ranking performance summary – previous

The ranking change has caused some products to shift position. But that happens every time we add a new product anyway.

These same changes have been made to the Wireless Ranker, which is where we rank non-routing wireless products like access points, bridges and adapters.

As we did with the other Rankers, the Router Ranker view can now be sorted by price as shown below. We also made help less obtrusive, but only a button click away.

Performance summary - previous

Router Ranker – Price sort

Router Chart Tweaks

We carried over the changes we made to the NAS Charts to the Router and other charts, too. You can also now sort the view by Class and Price ($$) in addition to performance (Throughput). Just click on the Class:Rank or $$ column titles as desired. Of course, you can also apply any of the filters and sort those views, too. The view below shows only AC1200 class routers sorted by low to high price.

SNB Router Chart - filtered and sorted by price

SNB Router Chart – filtered and sorted by price

We hope you like the changes. Be sure to let us know what you think either via the Forums or just by dropping us a line.

Go ahead and check out improved Router Ranker now!

Related posts

Does Alternative Firmware Break Your Router?

Alternative router firmwares like DD-WRT and Tomato are known for adding more features to routers. But we tested to see if they also take some features away.

Multicasting and the Small Network, Part 3

I've covered some of the basic elements of Multicasting, such as IGMP and the Layer 2 switching components in my previous posts (Part 2). This article will go into the technology behind Multicasts at Layer 3 and some of the issues limiting wider use of Multicast technology.

As you recall in my first post, I observed that Yahoo's transmissions of live NHL games would seem to be good candidates for Multicast, yet were being sent as unicast. Then I covered the simple issue of enabling Multicast within a local area network. Coming full circle, here we are diving into Multicast technology to understand why it isn't more widespread.

Introducing SmallNetBuilder’s Powerline Performance Charts And Product Finders

We are pleased to announce SmallNetBuilder's Charts and Product Finders for powerline networking products.