Like every other website on the planet, SmallNetBuilder uses cookies. Our cookies track login status, but we only allow admins to log in anyway, so those don't apply to you. Any other cookies you pick up during your visit come from advertisers, which we don't control.
If you continue to use the site, you agree to tolerate our use of cookies. Thank you!

Router Charts

Click for Router Charts

Router Ranker

Click for Router Ranker

NAS Charts

Click for NAS Charts

NAS Ranker

Click for NAS Ranker

More Tools

Click for More Tools

LAN & WAN News

The new line of "Linksys by Cisco" Powerline products include adapters based on both HomePlug 1.0 plus Turbo and HomePlug AV standards.

HomePlug 1.0 plus Turbo and AV products have maximum link rates of 85 Mbps and 200 Mbps respectively.

There are four new adapters—two with single 10/100 ports and two with four port 10/100 switches.

The Linksys by Cisco Powerline AV and Powerline Turbo lines will start shipping next month. MSRPs and model numbers are:

PLTE300 PowerLine Turbo Ethernet Bridge - $69.99

PLTS300 PowerLine Turbo 4-Port Ethernet Bridge - $89.99

PLTK300 Kit with PowerLine Turbo 4-Port Ethernet Bridge + Ethernet Bridge - $149.99

PLE300 PowerLine AV Ethernet Bridge - $89.99

PLS300 PowerLine AV 4-Port Ethernet Bridge - $99.99

PLK300 Kit with PowerLine AV 4-Port Ethernet Bridge + Ethernet Bridge - $179.99

More LAN & WAN

Wi-Fi System Tools
Check out our Wi-Fi System Charts, Ranker and Finder!

Support Us!

If you like what we do and want to thank us, just buy something on Amazon. We'll get a small commission on anything you buy. Thanks!

Over In The Forums

Been running this RT-AC86U for a little over a month now. 1st thing I did was to load Merlin firmware which seems to be running fine. A short while b...
I'm trying to build NoDogSplash on AsusWrt Merlin 384.14. Compile is fine, configuration also ok. But when I start nodogsplash, it complaining that ip...
I just replaced my Asus 1900P running Merlin with a Netgear r7800 running Voxel 1.0.2.72SF. So far it seems to be running well. Was curious if there a...
Hi Guys I'm totally new here, so forgive my ignorance. I've setup an RT-AC5300 at my in-laws home and put the Sky hub into Modem-Only mode (well, disa...
Hi. Noticed a few people in other posts mentioning that they use a higher end router as a node. I was thinking of doing this but not sure if it would ...

Don't Miss These

  • 1
  • 2
  • 3