Like every other website on the planet, SmallNetBuilder uses cookies. Our cookies track login status, but we only allow admins to log in anyway, so those don't apply to you. Any other cookies you pick up during your visit come from advertisers, which we don't control.
If you continue to use the site, you agree to tolerate our use of cookies. Thank you!

Wi-Fi Router Charts

Click for Wi-Fi Router Charts

Mesh Charts

Click for Mesh Charts

Internal Details

Figures 3 and 4 show the innards of the AP 200. You don't see a processor because it's part of the Atheros single-chip 2.4 GHz AP device located under the soldered-on RF shield. The FCC internal photo was no help either, being too fuzzy to determine the specific Atheros device.

The LED signal-bar display is on the small board you see mounted to the underside of the top cover. It connects to a 10 pin header on the main board via the flat cable that was disconnected for the photo.

 Inside view
Click to enlarge image

Figure 3: Inside view

The other devices that you can see are a Realtek RTL8201 single-chip 10/100 Ethernet interface, 32 MB RAM chip and Spansion FL064A Serial interface chip.

Main board
Click to enlarge image

Figure 4: Main board

And yes, that's right, the AP 200 performs all of its tricks with a single radio chip. So since the radio is doing double duty as a Wi-FI WAN client and WLAN router, you'll lose about half the wireless WAN throughput. You'll see what this means later in the Performance section.

Support Us!

If you like what we do and want to thank us, just buy something on Amazon. We'll get a small commission on anything you buy. Thanks!

Don't Miss These

  • 1
  • 2