Like every other website on the planet, SmallNetBuilder uses cookies. Our cookies track login status, but we only allow admins to log in anyway, so those don't apply to you. Any other cookies you pick up during your visit come from advertisers, which we don't control.
If you continue to use the site, you agree to tolerate our use of cookies. Thank you!

Router Charts

Click for Router Charts

Router Ranker

Click for Router Ranker

NAS Charts

Click for NAS Charts

NAS Ranker

Click for NAS Ranker

More Tools

Click for More Tools

Wireless Reviews

Introduction

NETGEAR WN2000RPT Universal WiFi Range Extender

At a Glance
Product NETGEAR Universal WiFi Range Extender (WN2000RPT)
Summary Easy-to-use dual-stream 802.11n wireless repeater / bridge with built-in four-port switch
Pros • Supports 300 Mbps maximum link rate
• Good setup wizard
• Can be used as repeater or bridge
• Doesn't require WDS
Cons • 2.4 GHz only
• Can't be used as access point
• Might not help much

Many products designed to stretch your wireless network's range have passed across the SNB test bench. Most don't deliver anywhere near what they promise, or require a router supporting WDS, or are near impossible to set up, or all the above.

So I cast a skeptical eye upon NETGEAR's WN2000RPT (not to be confused with its WNR2000 Wireless-N Router) as I unboxed it and prepared to be unimpressed. Little did I know that I'd be pleasantly surprised instead.

Inside

Figure 1 shows the inside of the WN2000RPT. Most of the good stuff is covered by RF shielding and heatsinks. But the FCC ID photos include a detail showing an Atheros AR9103 2.4 GHz 3X3 MIMO 802.11n radio, which is typically paired with an Atheros AR9132 3X3 Wireless Network Processor.

WN2000PT board

Figure 1: WN2000PT board

Note that this is a full dual-stream N extender, not single stream like the Innoband HomePlug AV Wireless N Kit. So you have more bandwidth to work with (or throw away due to repeating).

The design includes a four-port 10/100 switch, which I think is supported via an Atheros AR8236. So the WN2000RPT can also be used as a wireless bridge to wired clients, which will not suffer the 50% throughput reduction that wireless clients associated with it receive. 32 MB of RAM and 4 MB of flash finish up the design.

More Wireless

Wi-Fi System Tools
Check out our Wi-Fi System Charts, Ranker and Finder!

Support Us!

If you like what we do and want to thank us, just buy something on Amazon. We'll get a small commission on anything you buy. Thanks!

Over In The Forums

My clients are not able to connect to the internet, nor able to RDP to pc's after getting connected to my openvpn server on rt-ac3100 running 384.13. ...
If I were to add a MoCA adapter to my router and to the coax I realize I would use another bonded MoCA adapter somewhere else in the house.1. I also a...
I have a lan of 2 Win 10 PCs.If I type \\Htpc\!htpc in the address bar of a file explorer the remote share instantly shows up.When clicking on the Net...
I bought the switch from my other post. Do I have to connect it to my router? I thought I would not since the Thunderbolt 3 to 10GbE adapter connects ...
Hi, I have searched and see some code examples for different routers and such, but I would like to setup a guest network on my RT-AC88U router. It wi...

Don't Miss These

  • 1
  • 2
  • 3